|
|
Post by DIYDafty on Feb 17, 2021 20:18:42 GMT
Dafty dear boy, all you need to do is ask!! A Ladder TR sits higher up on the wall matey - 200-300mm from the floor to the bottom & you use Straight radiator valves. That just looks ‘Daft’😂😂🥺 Nope it looks fine but I am aware you have a feminine side which might explain why you're happy to give interior design comments.  I did it higher up the wall with chrome pipes coming out of the wall in the other bathroom but decided against here. Partly because the otherside of the stud wall is the airing cupboard so would need to remove cylinder, pump etc to get under the floorboards (or from below which also would be a ballache.) |
|
|
|
Post by rocketmanbkk on Feb 17, 2021 20:46:37 GMT
Silverline fatality !!!!  I heard silverline tools contribute to 75% of global land fill Agreed PB Agreed |
|
|
|
Post by endfeed on Feb 17, 2021 20:57:08 GMT
I feel over tightened as murdering fittings to death is common. However. It's also possible with either not deburring the pipe or the pipe had a bit bending former damage possibly? interesting you mentioned about deburring pipe battle. I was going to ask the Brew cabin members if they deburr or not?🤔🤔🤔 |
|
|
|
Post by pb on Feb 17, 2021 21:02:04 GMT
I feel over tightened as murdering fittings to death is common. However. It's also possible with either not deburring the pipe or the pipe had a bit bending former damage possibly? interesting you mentioned about deburring pipe battle. I was going to ask the Brew cabin members if they deburr or not?🤔🤔🤔 I can't stand Chris de Burgh  |
|
|
|
Post by tomplum on Feb 17, 2021 21:13:02 GMT
If i cut anything with a saw, I will deburr, If I cut it with a cutter, no, i don't the cutter puts a chamfer on the pipe so. its not needed,
|
|
|
|
Post by endfeed on Feb 17, 2021 21:24:55 GMT
If i cut anything with a saw, I will deburr, If I cut it with a cutter, no, i don't the cutter puts a chamfer on the pipe so. its not needed, the pipe slice gives a perfect finish, can't see the point deburr inside of pipe,what difference does it make the end product? |
|
|
|
Post by cylinderfella on Feb 17, 2021 21:25:49 GMT
interesting you mentioned about deburring pipe battle. I was going to ask the Brew cabin members if they deburr or not?🤔🤔🤔 I can't stand Chris de Burgh Hahaha! A new technical term.... Have you "Chrised" your pipes? |
|
|
|
Post by dickpuller on Feb 18, 2021 18:38:31 GMT
I always de-burr my copper tube after using cutters, he lied!!!
Never done it & don’t see the need👍
|
|
