|
|
Post by endfeed on Sept 4, 2016 19:12:02 GMT
Hi tom, any chance of a vid/chat on mini benders.done plenty 15 & 22 but no micro bore..cheers tom.😊
|
|
|
|
Post by tomplum on Sept 4, 2016 20:55:55 GMT
have a look here, if it don't answer your questions tell me what you need to know and i'll do another for you.
|
|
|
|
Post by dickpuller on Sept 11, 2016 10:46:39 GMT
Perhaps if you're doing a lot bending on microbore 8&10mm pipe you want to get yourself one of these. Don't buy a cheapo one as there's lots of clones that'll not fit metric tube. See the 'L' & 'R' marks on the guide, that's for you pencil Mark, so say you want a end to centre bend; you mark your tube, put in the bender with the pipe stop to the 'left' & line up your centre mark with the 'L', pull your 90. Vise versa for a right hand bend. Also other angles are marked on the former. Attachment DeletedAttachment DeletedAttachment Deleted |
|
