|
|
Post by battle1066 on Oct 18, 2022 17:40:53 GMT
Can you get paddle kits for the 2 port Drayton valves like you can for the Honeywell 2 port kits shown in the image?  |
|
|
|
Post by tomplum on Oct 18, 2022 18:47:13 GMT
I don't know Battle, I would change the whole valve ,  |
|
|
|
Post by battle1066 on Oct 18, 2022 18:55:53 GMT
Its not a bad job if you can do the internal swap as its the spindle seal which has failed.
However. A valve isn’t an option as its onto plastic after a short run of copper - looks very suspect and I know its not going to work out and its then a floor up and the tank out due the way its been installed and its just been fully carpeted in light colour.
|
|
|
|
Post by rocketmanbkk on Oct 19, 2022 6:39:34 GMT
Its not a bad job if you can do the internal swap as its the spindle seal which has failed. However. A valve isn’t an option as its onto plastic after a short run of copper - looks very suspect and I know its not going to work out and its then a floor up and the tank out due the way its been installed and its just been fully carpeted in light colour. Why don’t people think before they install? Probably trying to get in & out asap rather than taking 15 minutes to plan. |
|
|
|
Post by battle1066 on Oct 19, 2022 16:15:17 GMT
Its not a bad job if you can do the internal swap as its the spindle seal which has failed. However. A valve isn’t an option as its onto plastic after a short run of copper - looks very suspect and I know its not going to work out and its then a floor up and the tank out due the way its been installed and its just been fully carpeted in light colour. Why don’t people think before they install? Probably trying to get in & out asap rather than taking 15 minutes to plan. The install is just over fifteen years old as that’s the age of the dwelling - to busy for the job to go wrong so back heeled it currently till i get a valve and time. |
|
