|
|
Post by aj on Dec 14, 2016 22:03:25 GMT
hi.is there a way to store opened sillicant/sealant tubes so ican reuse them.i have tried the screw in the end but still dry up after some time.many thanks
|
|
|
|
Post by endfeed on Dec 14, 2016 22:56:31 GMT
I sqeeze a little silcone out the end when that drys it forms a cap.when you come to use again just pull the dry silcone cap out and fresh sicone will be there☺
|
|
|
|
Post by joinerjohn on Dec 14, 2016 23:03:29 GMT
I usually put a bit of cling film over the end, but replace the nozzle before using it again (goes off in the nozzle)  |
|
|
|
Post by crowsfoot on Dec 15, 2016 7:31:15 GMT
I insert a screw into the end of the tube after use.
I'm now going to try EFs method though.
Tappy,
|
|
|
|
Post by battle1066 on Dec 15, 2016 18:02:48 GMT
I too will have to try Endfeeds tip cause I just use the other two methods quoted, nail or new nozzle.
|
|
|
|
Post by endfeed on Dec 15, 2016 18:22:56 GMT
 The pressures on! I await your feedback😨
|
|
The pressures on! I await your feedback😨