|
Post by rocketmanbkk on Feb 1, 2017 19:23:04 GMT
Hello Friends
I've got a little leak to fix
Basically the overflow on the kitchen sink where the bendy pipe goes from the overflow & connect under the drain. There's an o ring there. The pipe goes over it but it drips.
The o ring is smooth & not broken.
Any thoughts on how to fix it?
Thx all
Rct
|
|
|
Post by tomplum on Feb 1, 2017 19:24:16 GMT
silicone will do it,
|
|
|
Post by rocketmanbkk on Feb 1, 2017 19:30:58 GMT
Ok thx Tom
I was thinking LSX
But silicone is cheaper
Rct
|
|
|
Post by crowsfoot on Feb 1, 2017 20:19:35 GMT
I always pop a bit of solvent weld glue on them whenever I fit these overflow combi wastes.
However, I don't think it would stick very well once it's been wet though.
Fairly cheap to buy a new one though rocky.
|
|
|
Post by rocketmanbkk on Feb 2, 2017 14:26:48 GMT
Fixed this one, the o ring was little hard, not sure why it leaked. Bit of tape sorted it.
Cheers all
|
|