Post by rocketmanbkk on Feb 4, 2017 16:49:30 GMT
So I personally tried power flux for ages & it make the fitting nearly unmoveable on the pipe, so I changed to laco which is good
Yesterday my mate introduced me to everflux. It's good, a tip he gave me was that the flame turned a greenish colour when the pipe was hot enough to melt the solder, it worked. It might help out the novice who's not 100% confident.
On the castle job I had a problem, fitted pipe & fittings together etc. Heated but solder wouldn't take, took apart, water in pipe, tried again, same, took me 4 attempts but sorted in the end. A good learning experience that, the solder was melting but just fell off the pipe.
Cheers all
Yesterday my mate introduced me to everflux. It's good, a tip he gave me was that the flame turned a greenish colour when the pipe was hot enough to melt the solder, it worked. It might help out the novice who's not 100% confident.
On the castle job I had a problem, fitted pipe & fittings together etc. Heated but solder wouldn't take, took apart, water in pipe, tried again, same, took me 4 attempts but sorted in the end. A good learning experience that, the solder was melting but just fell off the pipe.
Cheers all
