|
|
Post by rocketmanbkk on Sept 10, 2018 15:23:11 GMT
So, there are obviously rules for the depth that you can cut joists. I accept that.
Now then, what is the preferred method to sort a joist out if you have to cut it ‘too much’?
Cheers all
|
|
|
|
Post by endfeed on Sept 10, 2018 16:17:21 GMT
I coach bolt another joist over the bad part and put joist into wall.coach bolts done up nice and tight!👍🏼
|
|
|
|
Post by rocketmanbkk on Sept 10, 2018 16:27:33 GMT
I coach bolt another joist over the bad part and put joist into wall.coach bolts done up nice and tight!👍🏼 So how about if there are pipes there? Put decent wood either side of joist & bolt up? |
|
|
|
Post by crowsfoot on Sept 10, 2018 19:41:13 GMT
Not something I think about too much (as long as the pipes are covered by the notch). Close to the end of the joist is considered to be the best place to notch out, but it's not always possible. I think you can buy a metal plate to fit over the top of the pipes which offers some extra strength and protects the pipes from those ruddy joiners nails  . |
|
|
|
Post by tomplum on Sept 10, 2018 20:30:57 GMT
I think I was learned to notch at 20% of the joist lenght and never any more than needed, Now thats ok on new build where you can see all the joists and plan it out, But in a built house you cannot see the joist lenght, So basicly keep your notches to a minimum and as near a wall as pracical, never notch waste pipes and never notch the bottom of the joist and if you hear creaking as you notch, get the fuck out,  |
|
.
