|
|
Post by tomplum on Aug 17, 2019 12:01:16 GMT
|
|
|
|
Post by endfeed on Aug 17, 2019 12:11:14 GMT
On Thursday I was working down a alleyway cutting down pipes to size,van parked at distance, struggled my ass off cutting on the ground! Done some research for something to use. What your thoughts before I buy? What do you use?
|
|
|
|
Post by tomplum on Aug 17, 2019 12:18:01 GMT
I use anything to hand, bricks,wood, a wall, my tool bag and it is frustrating working on the floor so, if those are well priced I might have tried one out,  |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 17, 2019 12:34:42 GMT
I'm the same as Tom in I use what I have to hand which is usually my tool bag, I would say it's a handy device but that would depend on cost as I'm a tight arse  |
|
|
|
Post by DIYDafty on Aug 17, 2019 12:59:59 GMT
Looks like it works well with 110mm pipe but what about the smaller sized? 32mm etc ?
|
|
|
|
Post by endfeed on Aug 17, 2019 13:19:49 GMT
Toolstation are selling it for £21.98. Amazon£20 odd quid.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 17, 2019 14:06:58 GMT
Toolstation are selling it for £21.98. Amazon£20 odd quid. Are you getting one endfeed ? You do realise that buying more tools will result in Mrs Endfeed putting your nuts in it and stamping on them.  |
|
|
|
Post by endfeed on Aug 17, 2019 14:30:20 GMT
Getting one today,👍 don't tell Mrs E😨
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 17, 2019 14:44:16 GMT
|
|
|
|
Post by endfeed on Aug 17, 2019 19:42:50 GMT
Its orded, thinking about it you could make one out of ply board🙈
|
|
|
|
Post by tomplum on Aug 17, 2019 19:48:08 GMT
I thought that too endfeed but, it would have to be 1/2 inch at least and would start splitting after a while, I think you should get it, then in a couple of weeks give a warts an all review to our members, |
|
|
|
Post by endfeed on Aug 17, 2019 20:08:55 GMT
Will do,Tom👍👍👍👍👍
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 17, 2019 22:20:57 GMT
Look forward to your review endfeed |
|
|
|
Post by tomplum on Aug 18, 2019 9:55:41 GMT
one job I always struggled with was cutting boiler flues down, the metal is thin and you have 2 walls to cut through with only a short length of pipe, that contraption might prove to be worthy of its cost in that situation, or maybe adapt that idea to suit boiler flues,  |
|
|
|
Post by endfeed on Aug 19, 2019 17:48:41 GMT
|
|
