|
|
Post by endfeed on Sept 23, 2020 19:04:51 GMT
Attachment Deleted. I've got this tap to fit,but the one that's being taken out is on flexi's and Mr suit and boot says Flexi's out and piped up in copper.. the cooper tails in the picture have a built on female thread ready to drop onto the flat faced isolation valve, same set up as in picture. Any ideas for me to connect to the flat faced isolation valve. I think a female iron will be too long for the threads 
|
|
|
|
Post by endfeed on Sept 23, 2020 19:09:43 GMT
|
|
|
|
Post by battle1066 on Sept 23, 2020 19:13:20 GMT
Does the kit not come with rubbers gaskets?
|
|
|
|
Post by endfeed on Sept 23, 2020 19:13:33 GMT
I've just realised,tap conector will do it😂😂😂
|
|
|
|
Post by battle1066 on Sept 23, 2020 19:14:15 GMT
Not sure if it's the image but that pipe tail looks very long.
|
|
|
|
Post by endfeed on Sept 23, 2020 19:16:01 GMT
Does the kit not come with rubbers gaskets? Yes mate, it's like a hard plastic gasket  |
|
|
|
Post by endfeed on Sept 23, 2020 19:20:58 GMT
Not sure if it's the image but that pipe tail looks very long. 300mm. I've not seen copper tails with a built on female thread before 😯 |
|
|
|
Post by battle1066 on Sept 23, 2020 19:23:38 GMT
Not sure if it's the image but that pipe tail looks very long. 300mm. I've not seen copper tails with a built on female thread before 😯 Not done any with copper tails for an age. |
|
|
|
Post by endfeed on Sept 23, 2020 19:44:57 GMT
Apparently flexi's can cause legionnaire's, (load of bollocks)so if taps got flexi's we can't re use!
|
|
|
|
Post by battle1066 on Sept 23, 2020 19:56:04 GMT
Apparently flexi's can cause legionnaire's, (load of bollocks)so if taps got flexi's we can't re use! Bit late now. |
|
|
|
Post by tomplum on Sept 23, 2020 20:16:58 GMT
legionnaire's, is a lot like covid-19 Just wondering if there's a link, has flexi pipes caused this pandemic ?  |
|
|
|
Post by endfeed on Sept 24, 2020 14:16:32 GMT
Attachment Deleted.job done, top one fitted like a dream, second one looks bit rough, but hey oh stevie wonder would like to see it!😂😂😂😂😂
|
|
|
|
Post by tomplum on Sept 24, 2020 14:42:00 GMT
nowt wrong with that endfeed, sometimes you have to be resourceful,  |
|
|
|
Post by rocketmanbkk on Sept 24, 2020 18:39:16 GMT
What’s the crack with flexis on taps from an unvented?
|
|
|
|
Post by tomplum on Sept 24, 2020 20:56:39 GMT
they should be ok rockey, they are ok with high pressure |
|
