aj
head of marketing and bargains 
Posts: 541 
|
Post by aj on Mar 6, 2017 14:42:50 GMT
tom i seen this tip on the internet, wondering if you could do a vid on it and test the theory.
using pushfit on chrome pipe.
the one turn of the pipeslice trick.
Try it. Put your pipeslice on level with the end so the wheel indents the pipe about 15mm in. Just 1 turn. Push a push fit fitting on and you'll not pull it off.
|
|
|
|
Post by tomplum on Mar 6, 2017 15:20:17 GMT
I already did one for that AJ one of our other members brought it on the November tips comp, it works
|
|
aj
head of marketing and bargains
Posts: 541
|
Post by aj on Mar 7, 2017 20:08:39 GMT
ok thanks tom good to know it does work
|
|
|
|
Post by endfeed on Mar 23, 2017 19:48:04 GMT
Just a little tip!!! Fitting a sink today and had no lube to push waste pipe home so I used a little bit of sicone sealant on pipe and they pushed home a treat!!!!! Just like a cock slipping into a fanny  myth buster maybe tom?  |
|
|
|
Post by tomplum on Mar 23, 2017 21:07:58 GMT
yea,,why not,,
|
|
|
|
Post by endfeed on Mar 24, 2017 22:46:14 GMT
|
|
|
|
Post by tomplum on Mar 24, 2017 22:49:30 GMT
another gem there endfeed,,,I'll get round to um soon,,, |
|
|
|
Post by endfeed on Mar 24, 2017 22:50:48 GMT
Cheers tom, no rush mate |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 11, 2017 20:27:17 GMT
Heating a hacksaw blade to melt plastic pipe in awkward places i.e. Close to a skirting (toilet waste etc)
|
|
|
|
Post by endfeed on Apr 11, 2017 20:35:27 GMT
Myth buster time, tom please please ooo please..... |
|
|
|
Post by endfeed on Apr 11, 2017 20:50:27 GMT
How about cutting plastic pipe in awkward position with a piece of nylon string wrapped around pipe with a fast sawing action  |
|
|
|
Post by tomplum on Apr 11, 2017 20:52:07 GMT
myth busters weekend coming soon,,,, |
|
|
|
Post by endfeed on Apr 11, 2017 20:53:28 GMT
1787034013 yippee Yip eeeeeeeeeeeeeeeeeee!!!!! |
|
|
|
Post by endfeed on Apr 12, 2017 20:00:09 GMT
myth busters weekend coming soon,,,, Enjoyed vid tom, cheers mate ...think they use nylon string...builders string line |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 13, 2017 17:00:42 GMT
Another tip is that you can bend 22mm condensate/overflow pipe with your pipe benders to 45 degrees or slightly more I can't make a 90 degree but this can save fittings maybe this is an obvious trick
|
|
myth buster maybe tom?
